Illuminated pushbutton with touch surface in M22 design

Illuminated pushbutton with touch surface in M22 design

• Ergonomic working by softly touching the sensor
• Start-up delay prevents unintentional switching
• Plant condition indicated via RGB LEDs
• Various setting options such as colour, NO/NC or triggering via IO-Link
• Adjustable brightness and sensitivity in wet environments or when operators wear gloves

Illuminated capacitive touch sensor KT5110

Illuminated capacitive touch sensor KT5111

Illuminated capacitive touch sensor KT5106

Illuminated capacitive touch sensor KT5310

Illuminated capacitive touch sensor KT5112

Illuminated capacitive touch sensor KT5309

Illuminated capacitive touch sensor KT5102

Illuminated capacitive touch sensor KT5311

Illuminated capacitive touch sensor KT5150

Illuminated capacitive touch sensor KT5312

Illuminated capacitive touch sensor KT5151

Illuminated capacitive touch sensor KT5350

Illuminated capacitive touch sensor KT5320

Illuminated capacitive touch sensor KT6100

Illuminated capacitive touch sensor KT6101

Illuminated capacitive touch sensor KT6300

Illuminated capacitive touch sensor KT6301

Illuminated touch sensors in M22 design

Capacitive touch sensors can be used, for example, as a start and stop button on machines, as enable switches and for opening and closing gates. Compared to mechanical switches the sensors operate without wear. Dynamic touch sensors detect an approaching human hand and suppress interference such as water, layers of ice or foreign bodies to a large extent. However, a gloved hand will still trigger them. Static touch sensors detect hands and objects even through glass for as long as the sensing face is covered which provides, for example, protection against vandalism. With the latching operating principle it is possible to switch the sensor on by touching briefly and to switch it off again by touching briefly again. The housing with protection rating IP 69K is resistant to oils and also impact and scratch resistant. Powerful LEDs as optical feedback signal that the sensor has been activated. The green LEDs can be controlled separately and, for example, be used to indicate the status of plant and machinery.

The sensor can be installed in all housings with a Ø 22.5 mm hole.

-------------------------------------

CÔNG TY CỔ PHẦN KỸ THUẬT VÀ THƯƠNG MẠI THIẾT BỊ CÔNG NGHIỆP NTD
VPGD: Số 9, Ngõ 651/82/3 Minh Khai, Hai Bà Trưng, Hà Nội.
Hotline: 0971961212
Mail: sales@ntd-automation.com